Description
Akyapak PER 8X10 R Shot Blaster Machine
STANDARD FEATURES
- Machine suitable for shot blasting of beams, profiles, angles and pipes equipped with complete abrasive recovery system, including a bucket elevator, abrasive air wash separator, dust collector, roller conveyor and electrical components
- Parts
- Maximum passage section of pieces 31” (0.8 m) W x 40” (1 m) H
- Effective shot blasting: 24” (0.6 m) W x 31” (0.8 m) H
- Length: 10 ft. (3 m) to 26 ft. (8 m)
- Blasting cycle
The operator loads the profiles onto the entrance conveyor. Parts is fed into the entrance of the machine, it passes through the Blast Chamber, parts are them unloads at exit of machine chamber.
Inside the chamber, parts are blasted by four (4) turbines. The abrasive falls into the collection hopper mounted underneath where it flows into the foot of the bucket elevator to be carried up to the abrasive reclamation unit to be sieved and cleaned before going into the abrasive silo mounted underneath. Then the abrasive is re-fed to the turbines via the control valves. The blast chamber is sealed against stray abrasive by rubber sealing.
- Production
- 20” (0.5 m) to 80” (2 m) per minute
- Degree of cleaning: Not specify.
- Abrasive: S 330 / S390 steel shot.
- Operating conditions ambient temperature and humidity – (less than £ 110°F (45°C)
- Parts must be dry and free of oil and grease
- Beams and profiles must pass through the machine in vertical position (I) since to pass them in H position shot in the superior part of it would be accumulated.
- Form complex structures could be necessary to pass more than once by the machine because shadows produced by the same piece
- Omega-shaped profiles or similar could not properly shot blasted inside.
- The production can vary depending on the degree of cleaning, degree of rust, mill scale, and or other contaminants present.
- Cleaning speeds are based upon the use of good quality premium abrasive.
- Surface finish will vary with blast media selected.
- Profiles less than 10 ft. (3 m) long, light weight parts or parts that are not flat may be necessary to pass them through the machine in a rack or basket
Manufacturer Catalogue Information Akyapak PER 8X10 R Shot Blaster Machine :
SHOT BLASTING MACHINE
PER 8X10 R
MOST EFFICIENT SELF CONTAINED SHOT BLASTER FOR PROFILES, STRUCTURAL STEEL AND BEAMS.
o AUTOMATIC CLEANING PROCESS. o ENVIROMENTALLY FRIENDLY.
o CONSISTENCY FINISH.
RELEVANT FEATURES
• Automatic shot blasting process, does not require skilled labor
• Handle profiles up to 40-inch (1m) X 31 inch (0.8 m), including beams, angles, bars and tubes
• Four blasting turbines positioned 90 degrees to the passage of parts producing up to white metal
finish conditions
• For long life, the blast cabinet is made of steel 1010 with internal layer of manganese Steel (11/14%)
• Additionally, reinforcement in hot areas with high chrome cast steel plates (≥64Rc hardness)
• Blowers and external auger for the return of shot accumulated in blasted profiles
• Highly efficient abrasive recovery and separation system to prolong shot life
• Complete state-of-the-art air filter unit guarantee a dust free environment.
• Constructed in compliance with CE or NEMA standard regulations.
• Optional
o Electric motion detection sensor for elevator belt, screw and roller conveyor o Abrasive flow valve control with electrical linear actuators controlled by HMI o Transfer for loading and unloading parts
